- Cleans vehicles of all shapes and sizes up to 4.50m HIGH and 2.40m wide
- Oscillating high pressure water jets for ‘all over ‘cleaning
- All jets index towards front and rear of vehicle
- Completely automatic
- Brushless system for simple installation
The Automatic Truck Wash uses high pressure oscillating jets of water and SPEEDWASH High Foam Detergent to ensure ‘all over’ cleaning.
The jets are oscillating through an angle of 40 Degrees when washing the sides of the vehicle and they are indexed to point towards front and rear of the vehicles at the start and finish of the cycle. This system achieves maximum coverage and effectiveness.
The two arches are installed in the wash area 2m further apart than the longest vehicle which is to be washed.
The vehicle is driven slowly to the first arch. As it approaches it actuates the under floor proximity sensor and the detergent/water pump starts up. The vehicle is then sprayed by the detergent mixture from the oscillating jets in the arch as it drives slowly through. As it leaves the arch and the proximity sensor the pump switches off.
After a pause to allow the chemical to act on the dirt film, the lights change on the rinse arch, and indicate to the driver to proceed slowly through the second arch, which is also automatically controlled by proximity sensors, and the vehicle is thoroughly covered by rinsing water from the oscillating jets, which finally index towards the rear of the vehicle.
|Vehicle Height||Model No.||Width of Vehicle|
Standard Voltage- 380/440V/3HP 60 amps.
Pump-37kW-output-916 Litres per minute 200 psi